This is an install document for rubber dust boots on 034Motorsport Adjustable Upper Control Arm Kits for the B5/B6B7/C5 Chassis

The only tool required would be a pair of needle nose pliers.  The boots shoudl only be installed after the final alignment adjustment has been set.

First step, stretch the boot open with the pliers and begin to slide over the rod end.  The rubber stretches a lot and is very strong, so don't be afraid to make it fit.

Once the boot is slid over the rod end, insert the washer inside the boot on the back side

Install the bolt to hold in the pin, and pull the boot back around the outside of the washer to seal

All said and done it will look like this and be ready to install