Installation Instructions

Your kit will include the following: One stainless steel shifter body (long, round, with a half- ball on the bottom) One aluminum shifter clamp (small, rectangular) One tall, skinny spring (green) One 12mm rubber O-ring One 12mm snap ring One white plastic half-ball One small white plastic bushing One M6x 25mm allen-head bolt Two ball […]

Tools Required: 5mm Allen Wrench Screw Driver 1/4” Drill 10mm wrench Installation Disconnect battery ground Remove 4 bolts securing stock coilpack to engine, remove 2 ¼ turn bolts securing black plastic cover behind engine. Unplug stock coil harness from 2 power output stages, 2 coil power connectors, and remove the ground ring at the back […]

This is an install document for rubber dust boots on 034Motorsport Adjustable Upper Control Arm Kits for the B5/B6B7/C5 Chassis   The only tool required would be a pair of needle nose pliers.  The boots shoudl only be installed after the final alignment adjustment has been set.   First step, stretch the boot open with the […]

Please Note: This installation guide features photos of a B5 fuel pump assembly our 60mm adapter. Other models will be very similar, and our 39mm adapter installation is also similar. Step 1: Remove your OE fuel pump assembly; we recommend doing this with the fuel level below 1/8th of a tank. Step 2: Use a […]

This is an install document for rubber dust boots on 034Motorsport Adjustable Upper Control Arm Kits for the B5/B6B7/C5 Chassis and similar products. The only tool required is a pair of needle nose pliers.  The boots should only be installed after the final alignment adjustment has been set. First step, stretch the boot open with the pliers […]

Instructions shown for MkV Volkswagen GTI 2.0T FSI. Installation may vary slightly depending on exact model. 1)      Raise your vehicle securely using a lift or jackstands. 2)      Unbolt the exhaust hanger from the subframe. 3)      Locate the 12 bolts securing the subframe (circled in blue), and the 2 bolts attaching the dogbone (circled in red). Loosen the bolts […]

Wiring pinout to use our 034 High Output DIS Coil w/Built in Driver for your failing factory 3B coil: 3B Specific Wiring: Pin A: Green/White ECU Trigger Pin B: Brown/Red Ground Pin C: Brown/Red Ground Pin D: Brown/Red Ground Pin E: Blue/Black +12v Link to coil product page: http://store.034motorsport.com/034-high-output-dis-coil-w-built-in-ttl-driver-20731.html Enjoy!

Before ordering 034Motorsport Motronic Audi I5 software, you must make sure you're ordering correct software - which solves lots of problems down the line. Audi has two distributorless 20vt ECU's that are pin for pin compatible with each other, but very slightly different internally. The ECU found in the RS2 is unique, the rest of the […]