Motor Mount Pair, Motorsport, B6, B7, and C5 Audi V8
034Motorsport's Motorsport Engine Mounts are the new standard in track performance. Our mounts are engineered with racing in mind, and manufactured from billet aluminum and high-durometer rubber for the ultimate in performance and durability. The result is a locked-down drivetrain, solid shifting, and virtually no wheel hop. Motorsport Engine Mounts may cause a noticeable increase in noise, vibration, and harshness (NVH) inside of the cabin.
Please Note: Vehicles equipped with "Active Motor Mounts" require our Plug-In Bypass Resistors to keep the check engine light off.
NVH is the measurement of how much noise, vibration, & harshness gets transmitted into the cabin of your vehicle. These 034Motorsport Motor Mounts will transfer low to medium amounts of NVH to the cabin based on user feedback. NVH is subjective so some users may find NVH to be increased or decreased from our rating. If you are experiencing higher than quoted NVH with this product, please email email@example.com for further assistance.
We're proud to announce the availability of the Motorsport Engine Mount Pair for B6, B7, and C5 Chassis Audi V8 models!
034Motorsport's Motorsport Engine Mounts are the new standard in track performance. Our mounts are engineered with racing in mind, and manufactured from billet aluminum and high-durometer rubber for the ultimate in performance and durability.
The result is a locked-down drivetrain, solid shifting, and virtually no wheel hop. Street Density Motorsport Engine Mounts are better suited towards street-driven vehicles on which excessive noise and vibration are not desired.
- Manufactured from Billet Aluminum and High-Durometer Rubber
- Street Density - 65 Durometer
- Lifetime Warranty **
- Rebuildable Design
- Comes with M10 hardware for increased strength, and better performance (requires drilling, see note below)
- Reduced Drivetrain Slop
- Decreased Engine Movement Under Load
- More Direct Power Transfer
- Improved Shifting Feel
- Complete Drop-In Replacement of Factory Engine Mounts
- Sold in Pairs
- 1999 - 2005 Audi A6 (C5)
- 2001 - 2003 Audi S6 (C5)
- 2003 - 2004 Audi RS6 (C5)
- 2003 - 2005 Audi Allroad (C5)
- 2002 - 2005 Audi S4 (B6)
- 2006 - 2008 Audi S4 (B7)
- 2006 - 2008 Audi RS4 (B7)
- 4.2L FSI
**Limited Lifetime Replacement Warranty (Against failure from manufacturing defects. Applicable to the original purchaser only. If any part of the mount fails under normal use, upon 034Motorsport approval, replacement part(s) will be shipped at no charge to the customer for installation.)
Please Note: 10mm mounting hardware is provided. The stock mounts use 8mm studs, so drilling the stock engine mount brackets is required. These mounts cannot pivot once installed and bolted firmly in place.
For vehicles equipped with "Active Motor Mounts" our Plug-In Active Engine Mount Resistors must be purchased to keep the check engine light off.
Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.
Learn More: www.p65warnings.ca.gov