RacingLine Stud and Nut 80mm Conversion Kit / Ball Seat - most OEM wheels / Full Car Set

Remove and refit your wheels all the time? Racingline’s Stud & Nut 80mm length kit gives a stronger fixing method than using the original wheel bolts. Plus they're a much quicker method to swap wheels for motorsport / track use as well. This kit comes with ball-head nuts to suit factory wheels and 80mm stud length for cars running up to 20mm spacers.

Ever wondered why racecars use stud & nut kits? If you’ve ever had to remove and install your wheels quickly at the track then you’ll know how frustrating the factory wheel bolts can be. Lining up the bolt holes, bashing the wheel against your beautiful brake calipers, then cross-threading the bolts at the same time. All while trying to balance the weight of the wheel. RacingLine’s stud and nut kit replaces those fiddly bolts with this high tensile stud & lightweight wheel nut conversion. The kit gives a stronger fixation method than using the original wheel bolts whilst saving unsprung weight. With the benefit of being a much quicker method to swap wheels for motorsport and track use. Converting your car to RacingLine’s Stud & Nut Kit is a simple, reversible upgrade. Simply screw in the studs in place of your original wheel bolts, with allen drive inserts to make installation a breeze. This kit comes with 80mm stud length allowing for the safe use of spacer size setups up to 20mm (Note, we also offer 70mm stud length when running spacers of 0-10mm). Both conical and ball seat lug nuts are available to suit either factory or aftermarket wheels. This kit comes with ball-head nuts to suit factory wheels (plus a small number of aftermarket rims). It’s very important to check which ones you require before ordering. The M14 x 1.5 high tensile, heat treated high carbon steel Motorsport Studs far exceed the strength of the factory bolts for ultimate strength and safety. They have an internal 6mm allen stud drive for accurate fixations and 8mm of unthreaded stud shank for brake disc clearance. The kit uses oversize 19mm Wheel Nuts – giving a greater surface area for contact & ease of use. These open-ended nuts are machined from lightweight M14 x 1.5 7000-series aluminum, featuring a knurled outer collar for much easier finger grip. Beautiful midnight-black gloss anodized finish on the nuts will smarten up your car's looks as well as its practicality. This kit has Ball Seat Nuts – to suit most OEM wheels. Note that Conical Seat nuts are also available for most aftermarket wheels. Wheel nuts can be purchased individually should you run differing wheel types.

Warning: This product may contain a chemical known to the State of California to cause cancer, birth defects, or other reproductive harm.

Learn More: www.p65warnings.ca.gov